![]() Your holder should be replaced every month. Rinse – Rinse your contact lens holder with saline solution.Afterwards, you can either wear your lenses or store them in a saline solution. Let your contact lenses sit in the holder for a minimum of six hours. Make sure the holder is kept upright, allowing the neutralisation process to take place. Close – Screw shut the lids on your contact lens holder.If you have a built-in neutraliser, this step does not need to be taken. Neutralise – Drop a neutralising tablet into your contact lens holder.Never exceed the fill line marked on your holder. Fill – Pour 3 percent hydrogen peroxide solution into your lens holder, until it reaches the fill line.If you have a built-in neutraliser, you can ignore step 5. This usually takes the form of a platinum disc that turns hydrogen peroxide to water and oxygen. Some holders contain a built-in neutraliser. Remove – Remove your contact lenses, putting them into the appropriate slot of your contact lens holder.Dry – Dry your hands using a clean, lint-free towel.Wash – Wash your hands under the tap with antibacterial soap.To use Hydrogen Peroxide solution safely, you’ll need to take the following steps: It is also particularly effective at preventing acanthomoeba from entering the eye, which could otherwise cause serious infections. Hydrogen Peroxide offers an alternative for people sensitive to the preservatives in multipurpose solutions. Replace – Make sure to replace solution after every use of your lenses, and once every 72 hours when your lenses aren’t in use.Clean your holder with a toothbrush and solution every week, and replace it entirely every month. Clean – Rinse out your contact lens holder with saline solution after use. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |